How Does One Obtain Knowledge to Waterproof a Basement

The basement waterproofing systems and their working. To answer that question, let's first look at historically conventional basement waterproofing and how it is supposed to work.


If you imagine how a basement is first built, when the house it is sited in was first conceived, then basically the following happens:


A big hole in the ground is dug, the footer or foundations are laid, the walls of the basement are built and then the rest of the house follows.


From this list the most vital point is the top one - the vast crater dug in the earth
When basement walls are constructed there is an area outside the walls that must be filled. This void gets filled with loose backfill. The problem here is that water looks for the path of least resistance, and you've just given it just that with a huge pile of loose backfill, no matter how well it's been compacted.


This area is going to have water constantly seeping into it. The conventional basement waterproofing provides some form of drainage pipe for this water to drain away, but the problem with this is that often these pipes get silted up. It's natural enough, the water is bringing all sorts of suspension with it. The system can overload if the pipes get over-filled and then the pressure of the built up water would be concentrated on the outer basement walls. If there are crevices in the walls, water will push through even if the basement walls are waterproofed.


This kind of situation is persistent because the tubes that should drain the excess water eventually deteriorate.


A huge problem is that often there isn't access to these pipes. In an attempt to keep excess moisture out basement waterproofing also can be put onto the outer walls of the basement. This is also called a tanked system.


If you want to find out if you have water inside the concrete block of your walls simply tap a hole into the concrete block, near the floor, and see if you have water coming out of this block then you may want to consider a drained cavity waterproofing system this system drains the water from your walls, much the same way you just did, by adding drain holes in the bottom blocks that allows those areas to drain into a type of interior french drain system. To move water away from your property; it first must be collected and sent through drainage channels to a sump pump or a natural drainage field.


The waterproofing systems for basement are better systems because they are installed internally and have easy access ports for removing the silt etc. It takes minimal disturbance to the original basement where traditional tanking or other methods have failed.


In conclusion, you want a basement waterproofing system that will deliver:


- a permanent or long term fix
-stop water through the floor and walls -not disturb the exterior appearance of your home
-an approved method by home loan lenders -more affordable than other methods


From an expert in the field, not waterproofing can be a dumb and expensive mistake in the future. You should look at basement waterproofing not as an expense but as an investment in the value of your home.
Start using the waterproofing system for your basement with no hassle or hard work. Teach yourself the important steps and get an environment lacking problems by visiting the basement waterproofing website.